GE P50 Agile P253 User Manual

5 Configuration
P50 Agile P253
5-26
P253/EN M/C
2.3.8 Configuration Menu
2.3.8.1 View / Edit Settings
CONFIGURATION
Password protected window for “CONFIGURATION’’ settings:
Restore Defaults, Active Settings, Copy From, Copy To, Setting Group 1
(Enabled/Disabled), Setting Group 2 (Enabled/Disabled), System Config
(Enabled/Disabled), Overcurrent (Enabled/Disabled), Neg Sequence
O/C (Enabled/Disabled), Earth Fault 1 (Enabled/Disabled), Earth Fault 2
(Enabled/Disabled), Thermal Overload (Enabled/Disabled), Loss of Load
(Enabled/Disabled), CB Fail (Enabled/Disabled), Stall Detection
(Enabled/Disabled), Limit NB Starts (Enabled/Disabled), IFL, Measure’t
Setup, and Setting Values.
Restore Defaults
No Operation
Editable setting
By using the (+ /5) or (- /6) key, Restore Defaults can be set as
No Operation / All Settings / Setting Group 1 / Setting Group 2.
Active Settings
Group 1
Editable setting
By using the (+ /5) or (- /6) key, Active Setting can be set as Group 1
/ Group 2.
Copy From
Group 1
Editable setting
By using the (+ /5) or (- /6) key, Copy From can be set as Group 1 /
Group 2.
Copy To
No Operation
Editable setting
By using the (+ /5) or (- /6) key, Copy To can be set as No Operation
/ Group 1 / Group 2.
Setting Group 1
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Setting Group 1 can be Enabled /
Disabled.
Setting Group 2
Disabled
Editable setting
By using the (+ /5) or (- /6) key, Setting Group 2 can be Enabled /
Disabled.
System Config
Enabled
Editable setting
By using the (+ /5) or (- /6) key, System Configuration can be
Enabled / Disabled.

GE P50 Agile P253 Specifications

General

Brand	GE
Model	P50 Agile P253
Category	Relays
Language	English