– 20 –
Conversion to LP (Propane) Gas
WARNING: If you are using LP (propane) gas, all
adjustments described in the following steps must
be made before attempting burner adjustments or
using cooktop.
• Use only approved pipe dope resistant to LP
gas.
Note: The cooktop leaves the factory set for use
with natural gas. If you convert to LP gas, keep
instructions and orifices to convert back to natural
gas.
Parts
The kit should contain the following:
• 1 Orifice—Large size—104-WB28K0093
• 3 Orifices—Medium size—(number to come)
• 1 Orifice—Small size—82-WB28K0094
• 1 Maxitrol LP adapter—WB01K055
• 1 Tie-on card/label for regulator
If you do not have all above-listed components,
contact the nearest GE Service and Parts Center.
Total input rating after conversion:
• Four-burner cooktop 35,000 Btu/hr.
• Five-burner cooktop 44,500 Btu/hr.
Tools Required:
• Adjustable wrench
• Nut driver: 9/32 in. or 7 mm
Prepare Cooktop for Conversion
1. Turn OFF gas supply at shut-off valve.
2. Turn OFF electrical power to cooktop.
Convert the Surface Knobs
Valve
Shaft
GEA00254
1. Remove knobs from valve shafts.
2. Fully screw down brass low-flame adjustment
screws into valve bodies with clockwise
rotation.
3. Replace knobs and cams.
Convert the Surface Burners
Burner Cap
Burner Grate
Burner Bowl
Burner Head
GEA00255
1. Remove grates and burner caps.
Note: Each orifice has a number and letter “L”
indicating LP gas.
• There will be one extra medium orifice spud and
burner head when converting a four-burner
cooktop.
GEA00256
2. Using a 9/32-in. or 7-mm nut driver, remove
and replace brass orifice spud inside each
To Next Page
Loading...
Need help?
General
