– 22 –
Model PP 945 Test Location
Left Rear Element* RPSM J2 to J21-3
Left Front Element* RPSM L1 to J21-2
Right Front Element* RPSM L1 to J21-4
Right Rear Element* RPSM J2 to J21-1
Each element's hot light limiter switch and its wiring can be tested without removing the cooktop from its
installation. This test will aid the service technician in determining if the element should be replaced. This test
assumes the elements heat properly.
All circuits below element's glass top temperature of 150°F (66°C) should test open. If circuit tests 0
resistance, replace element.
All circuits above element's glass top temperature of 150°F (66°C) should test 0 resistance. If open, check
wiring and replace element, if necessary. Operate element, if necessary, then disconnect power before
testing cooktop.
Model PP 975 Test Location
Left Rear Element* RPSM L1 to J21-1
Left Front Element* RPSM L1 to J21-2
Center Element* RPSM L1 to J21-4
Right Front Element* RPSM L1 to J21-3
Right Rear Element* RPSM L1 to J21-5
* Requires opening the drop box.
Element Hot Light Troubleshooting
To Next Page
Loading...
