GE Profile PSB42LSRBV

– 11 –
To Use the Dispenser
Select CUBED , CRUSHED
or WATER .
Press the glass gently against the middle
of the dispenser pad.
The spill shelf is not self-draining.
To reduce water spotting, the shelf and
its grille should be cleaned regularly.
If no water is dispensed when the
refrigerator is first installed, there may be
air in the water line system. Press the
dispenser arm for at least two minutes to
remove trapped air from the water line
and to fill the water system. To flush out
impurities in the water line, throw away
the first six glassfuls of water.
CAUTION: Never put fingers
or any other objects into the ice crusher
discharge opening.
Locking the Dispenser
Press the LOCK/LIGHT
button for 3 seconds
to lock the dispenser
and control panel. To
unlock, press and hold
the button again for
3 seconds.
Dispenser Light
This button turns
the night light on the
dispenser on and off.
The light also comes
on when the dispenser
pad is pressed. If this
light burns out, it should
be replaced with a 6 watt
12V maximum bulb.
Quick Ice
When you need ice
in a hurry, press this
button to speed up ice
production. This will
increase ice production
for the following
48 hours or until you
press the button again.
Door Alarm
To turn the Door Alarm
on, press the DOOR
ALARM button once.
The ACTIVE light will
come on. To turn it off,
press it again. When the
DOOR ALARM is active,
the ACTIVE light will
flash if you open the
door and beep if you
keep the door open for
more than 2 minutes.
The light goes out and
the beeping stops when
you close the door.
Spill Shelf
LIGHT
LOCK
HOLD FOR
3 SECS
TO ACTIVATE
LIGHT
LOCK
HOLD FOR
3 SECS
TO ACTIVATE
QUICK ICE
DOOR ALARM
Icemaker Controls
Note: When QUICK ICE is selected,
the freezer temperature operates
at -9°F for 48 hours or until QUICK
ICE is pressed again. There is no
change of temperature on the
display panel.
In the event of a power loss, if the
freezer temperature is above 40°F,
Quick Ice will not restart. Below
40°F, the refrigerator will return to
the Quick Ice mode.
Display after power failure:
After a power failure, the
display will reset based
on freezer temperature.
If the freezer temperature
is below 40°F, the display
will retain the settings
prior to power loss. The
chart at the right describes
the possible settings.
Control Function Freezer<40°F Freezer>40°F
Refrigerator Set
Temperature
Previous Setting Default 37°F
Freezer Set Temperature Previous Setting Default (0°F)
Door Alarm Previous Setting Previous Setting
Dispenser Option Previous Setting Default (Crushed Ice)
Quick Ice Previous Setting OFF
Reset Filter Previous Setting Previous Setting
Lock Previous Setting Previous Setting
Dispenser Light Previous Setting OFF