GE Profile PSB42LSRBV

– 52 –
Service Diagnostics
Diagnostic Mode
1. To enter the diagnostic mode, the temperature
display must be lit up. If the temperature
display is not lit, press any pad on the overlay.
ICE DISPENSER
HOLD 3 SECS
LIGHT
QUICK ICECUBEDCRUSHEDWATERDOOR ALARM
LOCK
RESET FILTER
HOLD FOR
3 SECS
TO A CTI VAT E
COLDER WARMER
DISPLAY
TEMP
COLDER WARMER
0º
F IS RECOMMENDED
ADJUST TEMPERATURE
37º F IS RECOMMENDED
REFRIGERATOR
FREEZER
2. Press the 2 COLDER and 2 WARMER pads
simultaneously for three seconds. The FREEZER
and REFRIGERATOR displays will change to 0 0.
4. Once the displays indicate a test mode, press
any pad on the temperature board overlay,
other than the
COLDER or WARMER pads, to enter
that mode.
Note: A test mode must be selected within 30
seconds of entering the diagnostic mode or it
will time out, normal refrigerator operation will
resume, and the displays will turn off. Once a test
mode is selected, the display will fl ash to confi rm
the mode selected.
5. At the end of a test session, to exit the
diagnostic mode, do one of the following:
• Enter 1 on the
FREEZER display and 5 on
the REFRIGERATOR display. Press any pad
other than the COLDER or WARMER pads to
execute a system restart.
• Enter 1 on the FREEZER display and 6 on
the REFRIGERATOR display. Press any pad
other than the COLDER or WARMER pads to
exit the service diagnostic test mode.
• Recycle power to the unit through the
main switch. As a cautionary measure,
the system will automatically time out of
the diagnostic mode after 15 minutes of
inactivity. In the diagnostics mode, the unit
can be tested under different conditions.
COLDER WARMER
COLDER WARMER
0º
F IS RECOMMENDED
ADJUST TEMPERATURE
37º F IS RECOMMENDED
REFRIGERATOR
FREEZER
Press Simultaneously
3. To select a test mode:
a. Enter a numeric value (see Test Mode
Chart) on the FREEZER display using the
COLDER or WARMER pad.
Note: The COLDER pad decreases the numeric
value. The WARMER pad increases the numeric
value.
b. Enter a numeric value (see
Test Mode
Chart) on the REFRIGERATOR display using
the COLDER or WARMER pad.