32
3- Remove the tub cover 4- Remove the tub nut
Use a tub wrench (WX5X1325 ) to remove the left hand thread
tub nut. Same wrench used on a GE washer.
Note
: When re-assembling, use a hammer with the wrench to
tighten the tub nut. Hand tighten with the wrench then ¼ of a
turn using a hammer.
5- Remove the basket
7- The suspension rods are detached by pulling the rods up
and removing the socket.
6- Suspension
Before the outer tub is released, unlock the main harness and
the drain hose clips. Release the drain hose from the cabinet
so both components can be separated.
8-Once the tub is separated from the cabinet, lift the cabinet off
and turn the tub up side down.
To Next Page
Loading...
