33
Note: The motor, pump and was motor can be service from the bottom without remov-
ing the cabinet.
The next step in removing the transmission (mode shifter), it is to remove the belt and
the motor.
The belt can be forced over the transmission pulley.
9- Remove the belt. (The belt can be
forced over the transmission pulley).
10-Rmove motor
11- Remove the pulley and shifter gear.
(Use lock ring pliers to remove the lock
ring that holds the pulley to the transmis-
sion. Using any other tools can damage
the lock ring.)
12- Remove 2 (3/8) bolts to remove the
wax switch base. The base can also be
removed before removing the wax switch
to make the disassembling easier.
13- The capacitor is held in place with a
¼” screw.
To Next Page
Loading...
