Why is steam coming from the vent of my GE RBS360 Ranges?
When using the ovens, it is normal to see steam coming out of the oven vents of your GE Ranges. As the number of racks or amount of food being cooked increases, the amount of visible steam will increase.
Why is my food not baking properly in my GE Ranges?
If food does not bake properly in your GE Ranges, this could be due to oven controls improperly set, incorrect rack position or a rack that is not level. Also, incorrect cookware or cookware of improper size may be the cause, or the oven temperature may need adjustment. Ingredient substitution can also change the recipe outcome.
Why does my GE RBS360 Ranges display flashes?
If the display on your GE Ranges flashes, it indicates a power failure. Reset the clock.
Why is there steam from the vent of my GE RBS360 Ranges?
It is normal to see steam coming out of the oven vents of your GE Ranges when using the ovens. The amount of visible steam will increase as the number of racks or amount of food being cooked increases.
Why does the surface unit stop glowing when turned to a lower setting on my GE RBS360 Ranges?
The surface unit is still on and hot, this is normal for GE Ranges.
Why are there frequent cycling off and on of surface units on my GE RBS360?
Frequent cycling off and on of surface units on your GE Ranges is likely due to improper cookware. Use only flat cookware to minimize cycling.
Why is my GE Ranges smoking excessively during the clean cycle?
If you experience excessive smoking during the clean cycle of your GE Ranges, it's likely due to excessive soil or grease in the oven. Press the Cancel/Off pad, open the windows to ventilate the room, wait until the LOCKED light goes off, wipe up the excess soil, and then reset the clean cycle.
How to get the display to show “SF” on GE RBS360 Ranges?
If you're unable to get the display to show “SF” on your GE Ranges, it means the oven control pads were not touched properly. The Broil Hi/Lo and Bake pads must be touched at the same time and held for 3 seconds.
Why doesn't my GE Ranges drawer slide smoothly?
If the drawer does not slide smoothly or drags on your GE Ranges, the drawer may be out of alignment. Fully extend the drawer and push it all the way in. Also, the drawer may be overloaded or the load is unbalanced. Reduce weight and redistribute drawer contents.
Why am I getting control signals on my GE RBS360?
If you're getting control signals after entering a cooking time or start time on your GE Ranges, it means you forgot to enter a bake temperature or cleaning time. Touch the Bake pad and desired temperature, or the Self Clean pad and desired clean time.
Instructions and warnings for securing the range to prevent tipping.
Essential safety guidelines for using the appliance safely and preventing hazards.
Warnings about storing and using flammable items near the range to prevent fire.
Steps to take in case of a fire to prevent injury and limit fire spread.
Guidelines for safe operation of the cooktop surface units.
Important safety guidelines for operating the oven.
Safety precautions specific to the self-cleaning oven function.
How to operate the surface units and understand indicator lights.
Instructions for adjusting the oven temperature thermostat.
Steps for cleaning the oven interior manually with soap and water.
How to operate the self-cleaning cycle and important safety considerations.
Instructions for safely removing and reinstalling the oven door.
To Next Page
General