Why does my GE RBS360 Ranges sometimes take longer to preheat to the same temperature?
If your GE Ranges takes longer to preheat, it could be due to cookware or food in the oven, which will increase preheat time. Remove items to reduce preheat time. Also, the number of racks in the oven can affect preheating; remove some racks if needed.
Why does the power outage make the clock flashes on my GE RBS360 Ranges?
If the clock on your GE Ranges is flashing after a power outage or surge, you need to reset the clock. If the oven was in use, you must also reset it by pressing the Cancel/Off pad, setting the clock, and resetting any cooking function.
Why does my GE RBS360 Ranges display goes blank?
If the display on your GE Ranges goes blank, first check the fuse or circuit breaker in your home and replace it if necessary. It's also possible the clock is turned off, or the oven is in Sabbath Mode.
Why is there excessive smoking during broiling in my GE RBS360 Ranges?
If there's excessive smoking during broiling in your GE Ranges, it's likely because the food is too close to the burner element. Lower the rack position of the food.
Why is my GE RBS360 Ranges food not broiling properly?
To ensure your food broils properly in your GE Ranges, first make sure you've selected the correct broil mode. Refer to the Cooking Guide for rack position suggestions. Ensure the cookware is cool and suited for broiling. If using aluminum foil on the broiling pan and grid, fit it properly and slit as recommended. In some areas with lower voltage, preheat the broil element for 10 minutes.
Why is my GE RBS360 oven door crooked?
If your GE Ranges oven door is crooked, it may be out of position. Because the oven door is removable, it sometimes gets out of position during installation. To straighten the door, push down on the high corner.
How to fix GE RBS360 Ranges oven that will not self-clean?
If your GE Ranges oven won't self-clean, it could be due to a couple of reasons. If the oven temperature is too high, allow it to cool down before resetting the controls for a self-clean operation. Also, ensure that the oven controls are properly set by consulting the Cleaning the Oven section.
What to do if my GE RBS360 Ranges surface units aren't working?
If the surface units on your GE Ranges do not work properly, it could be due to a blown fuse or tripped circuit breaker in your home. Replace the fuse or reset the circuit breaker. Also, check to see the correct control is set for the surface unit you are using.
Why does my GE RBS360 make a clicking noise when using the oven?
If your GE Ranges is making a "clicking" noise when using the oven, it is normal. The range cycles the heating elements by turning relays on and off to maintain the oven temperature.
What to do if my GE Ranges oven door won't open after a clean cycle?
If your GE Ranges oven door will not open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature, and then you should be able to open the door.
Instructions and warnings for securing the range to prevent tipping.
Essential safety guidelines for using the appliance safely and preventing hazards.
Warnings about storing and using flammable items near the range to prevent fire.
Steps to take in case of a fire to prevent injury and limit fire spread.
Guidelines for safe operation of the cooktop surface units.
Important safety guidelines for operating the oven.
Safety precautions specific to the self-cleaning oven function.
How to operate the surface units and understand indicator lights.
Instructions for adjusting the oven temperature thermostat.
Steps for cleaning the oven interior manually with soap and water.
How to operate the self-cleaning cycle and important safety considerations.
Instructions for safely removing and reinstalling the oven door.
To Next Page
General