Why is the DOOR LOCK light on when I want to cook in my GE RBS360 Ranges?
If the door lock light is on when you want to cook with your GE Ranges, it means the oven door is locked because the temperature inside the oven hasn't dropped below the locking temperature. To fix this, press the Cancel/Off pad and allow the oven to cool down.
What to do if the 'LOCK DOOR' flashes on my GE RBS360 display?
If the "LOCK DOOR" is flashing in the display of your GE Ranges, it means the self-clean cycle has been selected, but the oven door isn't fully closed. Make sure to close the oven door completely to resolve this issue.
Why is the DOOR LOCK light on when I want to cook on my GE Ranges?
The DOOR LOCK light on your GE Ranges is on because the oven door is locked. The temperature inside the oven has not yet dropped below the locking temperature. Press the Cancel/Off pad and allow the oven to cool down.
Why does my GE Ranges oven door will not open after a clean cycle?
If the oven door of your GE Ranges won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool down below the locking temperature.
What to do if my GE Ranges oven does not work?
If your GE Ranges oven isn't working, first check the fuse or circuit breaker in your home and replace or reset it if needed. Ensure the oven controls are properly set. If a single bracket "]" appears in the display, press the Bake and Broil pads simultaneously for three seconds until "SF" appears. Then, press the Set Clock or Cook Time pad until "On" is displayed, and press Start. The display should then show the time of day.
What to do if my GE RBS360 Ranges coil surface units do not work properly?
If your GE Ranges coil surface units aren't working, first ensure the surface units are fully plugged into the receptacle with the controls off. Check that the correct control is set for the unit you're using. Also, make sure the drip pans are securely in the cooktop, with the opening aligned with the receptacle. Check your home's fuse or circuit breaker, and replace the fuse or reset the breaker if needed. If the Sensi-Temp Technology sensor cap is soiled, clean it according to the range's cleaning instructions. If the Sensi-temp sensor cap is stuck or won't flex, contact a qualified technician for replacement and use only the exact replacement part.
Why does my new GE RBS360 have a burning odor?
If you notice a “burning” or “oily” odor emitting from the vent of your new GE Ranges, this is normal and will disappear in time. To speed up the process, set a self-clean cycle for a minimum of 3 hours. See the Cleaning the Oven section.
Why does my GE RBS360 Ranges oven light does not work?
If your GE Ranges oven light isn't working, first check if the bulb is loose or defective and tighten or replace it. If the pad operating the light is broken, you will need to call for service.
How to fix a GE RBS360 storage drawer that won’t close?
If your GE Ranges storage drawer won’t close, the power cord might be obstructing it in the lower back of the range. Reposition the drawer and power cord. It's also possible the rear drawer support is on top of the guide rail; reposition the drawer accordingly.
What does it mean when “F— and a number or letter” flash in the display of my GE Ranges?
If “F— and a number or letter” are flashing on your GE Ranges display, it indicates a function error code. Press the Cancel/Off pad and allow the oven to cool for one hour before putting it back into operation. If the code repeats, disconnect power to the oven for at least 30 seconds, then reconnect. If the error persists, call for service.
Instructions and warnings for securing the range to prevent tipping.
Essential safety guidelines for using the appliance safely and preventing hazards.
Warnings about storing and using flammable items near the range to prevent fire.
Steps to take in case of a fire to prevent injury and limit fire spread.
Guidelines for safe operation of the cooktop surface units.
Important safety guidelines for operating the oven.
Safety precautions specific to the self-cleaning oven function.
How to operate the surface units and understand indicator lights.
Instructions for adjusting the oven temperature thermostat.
Steps for cleaning the oven interior manually with soap and water.
How to operate the self-cleaning cycle and important safety considerations.
Instructions for safely removing and reinstalling the oven door.
To Next Page
General