To Next PageTo Next PageWhy does “LOCK DOOR” flash on my GE RBS360 Ranges display?
If “LOCK DOOR” flashes in the display of your GE Ranges, it means the self-clean cycle has been selected, but the door is not closed. Simply close the oven door.
Why is my GE Ranges smoking excessively during broiling?
If there's excessive smoking during broiling with your GE Ranges, the food might be too close to the burner element. Try lowering the rack position of the food.
Why does GE Ranges surface unit stop glowing on lower setting?
If the surface unit of your GE Ranges stops glowing when turned to a lower setting, it is normal as the unit is still on and hot.
What to do if GE Ranges oven door will not open after clean cycle?
If the oven door of your GE Ranges won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
What to do when GE RBS360 clock flashes after power outage?
In case of a power outage or surge affecting your GE Ranges, reset the clock. If the oven was in use, you must reset it by pressing the Cancel/Off pad, setting the clock, and resetting any cooking function.
Why is my GE Ranges smoking excessively during clean cycle?
If there is excessive smoking during the clean cycle of your GE Ranges, it's likely due to excessive soil or grease. Press the Cancel/Off pad, open windows to clear the smoke, and wait until the LOCKED light turns off. Wipe up the excess soil and then reset the clean cycle.
How to adjust oven temperature on GE RBS360 Ranges?
If your GE Ranges oven temperature is too hot or too cold, it might need adjustment. Consult the Special Features section or adjust the thermostat if your model has an oven temperature knob.
What to do if my GE RBS360 Ranges coil surface units do not work properly?
If your GE Ranges coil surface units aren't working, first ensure the surface units are fully plugged into the receptacle with the controls off. Check that the correct control is set for the unit you're using. Also, make sure the drip pans are securely in the cooktop, with the opening aligned with the receptacle. Check your home's fuse or circuit breaker, and replace the fuse or reset the breaker if needed. If the Sensi-Temp Technology sensor cap is soiled, clean it according to the range's cleaning instructions. If the Sensi-temp sensor cap is stuck or won't flex, contact a qualified technician for replacement and use only the exact replacement part.
Why does my GE RBS360 oven sometimes take longer to preheat?
If sometimes the oven takes longer to preheat to the same temperature on your GE Ranges, the cookware or food in the oven will cause the oven to take longer to preheat. Remove items to reduce preheat time. Also, adding more racks to the oven will cause the oven to take longer to preheat so remove some racks.
Why does my GE RBS360 Ranges have a strong odor?
If you notice a strong odor from your GE Ranges, it is normal for the first few times the oven is used due to the insulation around the inside of the oven. This is temporary and will go away after several uses or a self-clean cycle.
Instructions and warnings for securing the range to prevent tipping.
Essential safety guidelines for using the appliance safely and preventing hazards.
Warnings about storing and using flammable items near the range to prevent fire.
Steps to take in case of a fire to prevent injury and limit fire spread.
Guidelines for safe operation of the cooktop surface units.
Important safety guidelines for operating the oven.
Safety precautions specific to the self-cleaning oven function.
How to operate the surface units and understand indicator lights.
Instructions for adjusting the oven temperature thermostat.
Steps for cleaning the oven interior manually with soap and water.
How to operate the self-cleaning cycle and important safety considerations.
Instructions for safely removing and reinstalling the oven door.
General