Read these instructionscompletely and carefully.
ToolsYouWill Need
Forlevelinglegs:
• ( hannel lock pliers
Forgassupplyconnection:
• Pipe wrench
ForconversionfromNaturalto LPgas:
• 1/2-inch open-end wrench
Forburnerflameadjustment:
• Phillips head and bladeqype s(rewdrivers
p
Additional Materials YouMay Need
• (;as line shut-offvalve. ForFlexibleConnection:
• Pipe joint sealant that resists action of I 2 gas.
• 1/2-inch pipe nipple,
ForRigidConnection:
• Pipe fittings as required.
• Flexible metal appliance connector
(same 3/4-in(h or 1/2-in(h I.D. as gas
supply line).
• Flare union adapter line
(1/2-m( h NPT x 3/4-m( h or 1/2-m(h I.D.).
Installo gtheBackguard
[] Remove the cooktop.
[] Place the backguard on top of the end panels
at the rear of the range.
[] (_onnect the "disconnect plug" (for power u)
the ba( kguard fiom the range).
[] Insert the machine screws through the lower
inside flange ofthe end (aps and the end
panels. Se(ure with the hex nuts provided.
[]
Insert the inachine screwsthrough the
elongated holes at the bottom of the
backguard and side flange of the burner box.
Secure xdth the hex nuts provided.
[] Attach the lower edge of the backguard to
the vent outlet with 2 sheet inetal sciews.
25
To Next Page
Loading...
