Installationof the range.
Read these instructionscompletely and carefully.
ToMake Electrical Connection(if range has electric ignition)
CAUTION--FOR PERSONALSAFETY."DO NOT
USEAN EXTENSION CORD WITH THIS
APPLIANCE.
• This appliance nmst be supplied xdth the
proper voltage and flequemy, and connecled
to an in(fivi(hml, property grounded and
pol_uized branch dr(uit, protected by a circuit
breaker or time<lel Wfi]se, as noted on the
rating plate.
• '_,\tfing nmst contoHn/o National Electric
(odes or the prevailing local code fi)ra range t)f
this kilowatt rating. (See the rating pla/e under
the cooklop fi)r this intonnation.)
• If the electric supply provided does not meet
the above spe(ifi(ations, (all a li(ensed
elecuician.
WARNING!
Electrical GroundingInstructions
This appliance is equipped with a throe prong
grounding plug for your protection against shock
hazard and should be plugged dirocfly into a
properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
INSURE PROPERGROUNDEXISTSBEFOREUSE
Light and Adjust Surface BurnerPilots (if range has standing pilots)
[] Purge all air flom supply system by ranting
one top bunmr valve fhlly ONfor 15se(onds. _!_ Topburnerpilots _,_
[] Tmnvalve OFFandlight pilot bmners.
A(!iust pilot fl_unes using the a(!iusting s(rew
on tl_e back oflhe thermostat, so that each
flame is approximately 1/4-inch in height.
[] To light any top bmner, push and turn
bmner knob to the LIFEposition.
Toppilots adjustment
screwcontrolsthe
rate ofgasto the top
burnerpilots.
[] When burner has ignited, rotate knob 1o
desired flame setting.
Manifold pipe
Tbermostat
Thermostat
Sensor,_,
30
To Next Page
Loading...
