GE T2100-ST1 Service Manual

Troubleshooting
86 T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-002 Rev G
11 March 2019
Smart Power Supply Error Code Identification Flow Chart 1I
1I
Is the Red LED D13
flashing on the
Smart Power Supply
PCBLF0443-1?
No
Yes
Verify the error code by counting the flashes.
The error flashes are very consistent and
then a long pause.
Verify the Emergency Stop Button is
released or Pull Tether missing.
Verify when the Emergency Stop
Button is released the Smart Power
Supply PCBLF0443-1 initial power up
returns to the parked position.
Treadmill should
be operational.
Reference Smart Power Supply Error Code, 1
Flow Chart 1J. Reason for error flashes Bad
Calibration Error (1).
Reference Smart Power Supply Error Code 2,
Flow Chart 1K. Reason for error flashes
Elevation Error (2).
Reference Smart Power Supply Error Code 3,
Flow Chart 1L. Reason for error flashes Zero
Speed Motor Controller Error (3).
Reference Smart Power Supply Error Code 4,
Flow Chart 1M. Reason for error flashes Over
Speed Motor Controller Error (4).
Reference Smart Power Supply Error Code 5,
Flow Chart 1N. Reason for error flashes Zero
Speed External Sensor Error (5).
Reference Smart Power Supply Error Code 6,
Flow Chart 1O. Reason for error flashes Over
Speed External Sensor Error (6).
Reference Smart Power Supply Error Code 7,
Flow Chart 1P. Reason for error flashes Speed
Compare Error (7).
Reference Smart Power Supply Error Code 8,
Flow Chart 1Q. Reason for error flashes
Motor Control Fault Signal (8).
Reference Smart Power Supply Error Code 9,
Flow Chart 1R. Reason for error flashes Belt Start
Reject Error (9).
Reference Smart Power Supply Error Code 10,
consult the factory for trouble shooting.

GE T2100-ST1 Specifications

General

Motor	2.5 HP
Incline	0-10%
Running Area	20" x 55"
Weight Capacity	250 lbs
Programs	6
Display	LCD
Folding	Yes
Incline Range	0-10%