GE T2100-ST1 Service Manual

Component/FRU Removal and Replacement
2097937-002 Rev G T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 151
11 March 2019
Fig. C
8. Reverse step 1 through step 7 to reinstall the STS assembly.
Replacing the Right or Left Handrail
Tools Required
o
1/8” Allen Wrench
o
5/32” Allen Wrench
o
5/16” Allen Wrench
o
Flat head screwdriver
o
Grounding Wrist Strap
Approximate time to complete: 30 min
NOTE
When replacing all the handrails, remove the center
handrail before proceeding with the left and right
handrails. See “Replacing the Center Handrail” on page 153
for instructions.
1. Turn the treadmill’s power switch to the OFF position.
2. Unplug the treadmill from the wall receptacle.
3. Allow the treadmill to discharge for 1 minute.
4. Remove the ESB or STS assembly.
See “Replacing the Emergency Stop Button (ESB)” on page
148 or “Replacing the Stop Tether Switch (STS)” on page 150
for instructions.
CAUTION:
Use ESD precautions, including wearing a grounding
wrist strap that is connected to an exposed metal
connection point on the treadmill chassis.
STS Connection on
outer spade blades.
Outside Terminal Contact

GE T2100-ST1 Specifications

General

Brand	GE
Model	T2100-ST1
Category	Treadmill
Language	English