GE Multilin L60 Line Phase Comparison System 7-7
7 COMMANDS AND TARGETS 7.2 TARGETS
7
• How often the test is performed: Event driven. The test is performed when a device programmed to receive GOOSE
messages stops receiving. This can be from 1 to 60 seconds, depending on GOOSE packets.
• What to do: Check GOOSE setup.
• Latched target message: Yes.
• Description of problem: Abnormal restart from modules being removed or inserted while the L60 is powered-up, when
there is an abnormal DC supply, or as a result of internal relay failure.
• How often the test is performed: Event driven.
• What to do: Contact the factory.
UNEXPECTED RESTART:
Press “RESET” key
To Next Page
Loading...
