GE Multilin L60 Line Phase Comparison System C-27
APPENDIX C C.7 LOGICAL NODES
C
RSYN: Synchronism-check or synchronizing ---
C: LOGICAL NODES FOR CONTROL
CALH: Alarm handling ---
CCGR: Cooling group control ---
CILO: Interlocking ---
CPOW: Point-on-wave switching ---
CSWI: Switch controller Yes
G: LOGICAL NODES FOR GENERIC REFERENCES
GAPC: Generic automatic process control ---
GGIO: Generic process I/O Yes
GSAL: Generic security application ---
I: LOGICAL NODES FOR INTERFACING AND ARCHIVING
IARC: Archiving ---
IHMI: Human machine interface ---
ITCI: Telecontrol interface ---
ITMI: Telemonitoring interface ---
A: LOGICAL NODES FOR AUTOMATIC CONTROL
ANCR: Neutral current regulator ---
ARCO: Reactive power control ---
ATCC: Automatic tap changer controller ---
AVCO: Voltage control ---
M: LOGICAL NODES FOR METERING AND MEASUREMENT
MDIF: Differential measurements ---
MHAI: Harmonics or interharmonics ---
MHAN: Non phase related harmonics or interharmonic ---
MMTR: Metering ---
MMXN: Non phase related measurement Yes
MMXU: Measurement Yes
MSQI: Sequence and imbalance ---
MSTA: Metering statistics ---
S: LOGICAL NODES FOR SENSORS AND MONITORING
SARC: Monitoring and diagnostics for arcs ---
SIMG: Insulation medium supervision (gas) ---
SIML: Insulation medium supervision (liquid) ---
SPDC: Monitoring and diagnostics for partial discharges ---
X: LOGICAL NODES FOR SWITCHGEAR
XCBR: Circuit breaker Yes
XSWI: Circuit switch Yes
T: LOGICAL NODES FOR INSTRUMENT TRANSFORMERS
TCTR: Current transformer ---
TVTR: Voltage transformer ---
Y: LOGICAL NODES FOR POWER TRANSFORMERS
YEFN: Earth fault neutralizer (Peterson coil) ---
YLTC: Tap changer ---
YPSH: Power shunt ---
YPTR: Power transformer ---
Table C–1: IEC 61850 LOGICAL NODES (Sheet 2 of 3)
NODES UR-FAMILY
To Next Page
Loading...
