FunctionSignalPin
Toggles the system between Run and EndRun/Stop (In)8
Negative edge selects Run-mode (starts)
Positive edge selects End-mode (stops)
Negative edge makes an event mark on
recorder
Event Mark (In)9
Connecting to supply voltage
ActionStep
Make sure the on/off switch is in the OFF position (O).1
Connect a mains cable between the instrument and a grounded mains
socket. The instrument is delivered with both European and US type mains
cables, as standard. Any voltage 100 V to 240 VAC, 50 Hz to 60 Hz, can be
used.
2
36 Monitor UVis-920 Operating Instructions 29055049 AD
4 Installation
4.6 Connecting electrical cables
To Next Page
Loading...
