GE UVis-920 - Page 49

DisplayActionStep
Enter the calibrated value of the cell path length if
available, press OK. The cell type must always be set
before the calibrated cell path length.
5
Setting run and end timers
DisplayActionStep
Select menu RunTimer End Timer,, press OK.1
Set run time, press OK to select action. Choose the
Run mode time 1 minutes to 999 minutes. Timer is
disabled if set to 0. If timer is enabled by OK, the re-
maining minutes to run are shown.
2
Set end time, press OK to select action. Choose the
End mode time 1 minutes to 999 minutes. Timer is
disabled if set to 0. If timer is enabled by OK, the re-
maining minutes to run are shown.
3
Press Esc key to return to the RunTimer End Timer
menu which now shows the countdown time and
end time.
4
Setting unit number
For service use only.
Monitor UVis-920 Operating Instructions 29055049 AD 49
5 Operation
5.8 Setup menu