Preparing for a guided procedure with Vscan Air
Vscan Air – User Manual 5-87
Direction GP092020-1EN Rev 18
General considerations
• There may be differences in the physical characteristics of a
wireless probe (shape, design, weight etc.) and the way it
might be handled during a scan or a procedure when
compared to a probe attached to a console. Hence, it is
recommended for users to get comfortable with handling the
Vscan Air device prior to performing a procedure to
minimize accidental dropping or slipping of the probe during
the procedure.
• Wherever possible, prior use of the probe and preferred
display device in the network environment where the
procedure is expected to be performed will help uncover any
unexpected challenges with a stable connection between
the probe and app before the actual procedure.
• Make sure to follow the disinfection protocol to prepare the
probe and display device for the procedure being
performed. More information on cleaning and disinfection
methods and approved agents can be found in the ‘Cleaning
and Disinfection’ section of the user manual. Use probe
sheaths for procedures where a sterile field needs to be
maintained or infection is a concern.
• In order to make the interventional part of the procedure
more efficient, and if this is not an emergency procedure,
you may want to perform a preliminary scan to familiarize
yourself with anatomical landmarks around the target and
procedural planning like the anticipated entry point, needle
path and tracking method. It might be helpful to mark
transducer location, anticipated needle entry point and
trajectory, whenever possible and appropriate.
To Next Page
Loading...
Need help?
General
