GE Vscan Air - Scanning

Using Vscan Air CL
5-4 Vscan Air – User Manual
Direction GP092020-1EN
Rev 18
Scanning
General scanning recommendations
Before each use:
Inspect the Vscan Air CL probe (see ‘Inspection’ on page 6-3).
After Each Use
• Inspect the Vscan Air CL (see ‘Inspection’ on page 6-3 )
• Clean the Vscan Air CL (see ‘Cleaning and disinfection’ on
page 6-6).
• If required, disinfect the Vscan Air CL (see ‘Cleaning and
disinfection’ on page 6-6 ).
Ensure that the Vscan Air CL is properly cleaned and disinfected
after each use and before storing in the protective case.
Use of Gel
In order to ensure optimal transmission of energy from the
transducer to the patient, a conductive gel must be applied on
the transducer lens.
WARNING
If any damage is found on the Vscan Air CL, do not use it.
Contact GEHC service.
CAUTION
If the gel comes in contact with the eye, consult the gel
manufacturer's instructions.