GE Vscan Air User Manual

Safety
2-14 Vscan Air – User Manual
Direction GP092020-1EN
Rev 18
Electromagnetic immunity
Table 2-2: Electromagnetic immunity (Part 1)
Guidance and manufacturer’s declaration – electromagnetic immunity.
The Vscan Air CL probe is intended for use in the electromagnetic environment below.
The customer or the user of the Vscan Air CL should assure that it is used in such an
environment.
Immunity test EN/IEC 60601
test level
Compliance
level
Electromagnetic
environment –
guidance
Electrostatic
discharge (ESD)
EN/IEC 61000-4-2
±8 kV contact
±15 kV air
±8 kV contact
±15 kV air
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material, the
relative humidity
should be at least
30%.
Electrical fast
transient/ burst
EN/IEC 61000-4-4
±2 kV for
power-supply lines
±1 kV for input/
output lines
±2 kV for
power-supply
lines
±1 kV for input/
output lines
Mains power quality
should be that of a
typical commercial or
hospital environment.
Surge
EN/IEC 61000-4-5
±1 kV line(s) to
line(s)
±1 kV line(s) to
line(s)
Mains power quality
should be that of a
typical commercial or
hospital environment.

GE Vscan Air Specifications

General

Battery Life	Up to 50 minutes of scanning
Type	Handheld Ultrasound
Display	Via mobile device (not included)
Connectivity	Wi-Fi
Probe Type	Dual-probe
Charging Time	Approximately 2 hours
Charging	USB-C
Water Resistance	IP67
Transducer Type	Phased Array and Linear Array
Imaging Modes	Color Doppler
Operating System	Android, iOS
Storage	Via mobile device (not included)
Compatibility	Compatible with Android and iOS devices