Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
Illustration Component Test Procedure Results
Motor
Type of motor:
Two speed
See following section “Internal Motor
Diagram and Schematic” for correct
wiring contacts.
Drain pump Verify drain pump is not clogged or
damaged.
Remove clog and verify proper operation.
Replace drain pump if damaged.
Transmission
assembly
Type of transmission:
640 rpm
If transmission locks-up, replace.
Drive belt Type of drive belt:
640 rpm
Refer to “Parts Manual” for proper
pulley size.
Refer to “Parts Manual”, to verify which
drive belt and pulley size is required.
Power Cord Measure resistance of wires. Continuity should be indicated on each
wire.
Verify polarity and grounding.
9
To Next Page
Loading...
