To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
Disassembly Procedures
28
WARNING
Cabinet Top
1. Remove control hood assembly, see “Control Hood
Assembly” procedure.
2. Remove front panel, see “Front Panel” procedure.
3. Remove screws securing cabinet top.
4. Tape loading door closed.
5. Lift front of cabinet top slightly and pull forward
to disengage from rear hold-down brackets.
6. Pull cabinet top forward far enough to permit
disconnecting ground wires from top left rear
corner gusset of washer cabinet.
7. Disconnect wire terminals from door switch.
NOTE: See appropriate wiring diagram when rewiring
components.
8. Lift cabinet top off washer and set along side the
washer cabinet on a protective padding.
NOTE: DO NOT lay cabinet top flat because it will
damage the door switch lever.
9. Reverse procedure to reassemble.
Door Switch
1. Remove front panel, see “Front Panel” procedure.
2. Remove screws securing cabinet top.
3. Tape loading door closed and lift cabinet top to a
vertical position by hinging it on the rear hinges.
NOTE: Cabinet top is self supporting, a small chain
may be used for additional support.
4. Disconnect wires from door switch.
5. Remove screw securing door switch assembly to
underside of cabinet top.
NOTE: See appropriate wiring diagram when
rewiring components.
6. Remove screws securing switch to switch holder.
7. Remove switch from switch holder.
8. Reverse procedure to reassemble.
Water (mixing) Valve
1. Disconnect water inlet hoses.
2. Remove screw securing mixing valve bracket.
3. Pull mixing valve bracket and valve out the back
of washer.
4. Disconnect quick disconnect terminals from mixing
valve solenoid terminals.
NOTE: See appropriate wiring diagram when rewiring
components.
5. Reverse procedure to reassemble.
NOTE: In warm water setting, both solenoids are
energized. The valves open 100% and the valve
orifice size meters the water to a 60% cold
water and 40% hot water mix.
To Next Page
Loading...
