60
in.xe™"Pump 2 or blower doesn't work" steb-by-step
Pump 2 or blower
is not working!
• Check for an error condition
on keypad display. If there is
one, refer to the specific sec-
tion indicated by the error
condition.
• Verify low level program-
ming configuration.
• If “Pump 2” or "Blower" indicator does not appear, use a spare
keypad to verify if keypad is defective.
If it is, replace keypad.
If not, replace Spa Pack.
• If “Pump 2” indicator appears when Key 2 button is pressed,
verify if pump works in either speed (if dual speed pump).
• Verify if “Pump 2” or "Blower"
indicator appears on keypad
display when you press Key 2
button.
* Only available on IN.XE-5-XX-XXX
To Next Page
Loading...
Need help?
General
