77
in.xe™
step by step field replacement procedure
Feed the cable of the new
keypad through the hole
opening in the spa.
Orient the cable's connector
towards the in.xe™ pack to
facilitate its connection later.
Insert the keypad in the
opening.
Peel off the double-sided tape
protective layer from the back
of the keypad.
Make sure that the keypad is
well aligned and rests perfectly
in the recess of the spa.
With an scraper tool, gently
clean the surface of installation
of the new keypad, finish the
job with an alcohol saturated
paper towel to remove any
unwanted residue left over
from the old keypad.
To Next Page
Loading...
Need help?
General
