Need help?Do you have a question about the Gecko MSPA-MP METAPAC and is the answer not in the manual?
General| Brand | Gecko |
|---|---|
| Model | MSPA-MP METAPAC |
| Category | Industrial Equipment |
| Language | English |
A step-by-step flowchart to diagnose and resolve issues related to Ground Fault Circuit Interrupter (GFCI) trips.
Explains common causes of GFCI trips and provides tests to identify and correct power supply problems.
Explains how to modify MSPA-MP spa pack parameters by changing jumper positions on the board.
Details how to configure system operating parameters from the keypad, including pump, blower, and filter settings.
Provides a flowchart to identify the cause of three flashing dots on the keypad display, typically a pressure switch issue.
Troubleshooting flowchart for when the system detects high temperatures (112°F+) causing the display to flash.
Troubleshooting flowchart for when the system displays an incorrect temperature, indicating a regulation sensor issue.
Flowchart for FLO error (pump on, no water pressure), focusing on pressure switch and flow issues.
Troubleshooting flowchart for HL error, related to Hi-Limit sensor or temperature probe issues.
Troubleshooting flowchart for when the system shows no activity, focusing on power supply and keypad connection.
Flowchart to diagnose why the spa is not heating, checking error conditions, temperature settings, and heater components.
Flowchart to identify why Pump 1 or Pump 2 is not working, checking error conditions, programming, and voltage.
Flowchart to diagnose why the blower is not working, checking indicators, voltage, and potential air entry issues.
Flowchart for spa light issues, checking bulb, keypad indicators, programming, and voltage at the output.
Flowchart for ozonator failure, checking programming, voltage, and fuse issues.
Flowchart to diagnose circulation pump failure, checking programming, voltage, and fuse.
Flowchart for diagnosing unresponsive keys on the keypad, checking jumper settings and keypad functionality.
Step-by-step instructions for safely removing and replacing the main circuit board of the MSPA-MP system.
Detailed instructions for replacing the heater in the standard horizontal/front/bottom configuration.
Provides procedures for adjusting the pressure switch, both with and without a voltmeter.
Lists part numbers, descriptions, and suggested retail prices for MSPA-MP components.
Illustrates the wiring connections for a vertical installation of the MSPA-MP system.
To Next Page