2 - ALARM AND RINGER SETTINGS
A 3 position switch located on the right side of the
phone allows the settings below:
- : Ringer and strobe flash are activated.
- : Ringer and shaker are activated.
- : Ringer, shaker and strobe flash are
activated.
3 - DIALLING MODE (T/P)
The Tone/Pulse switch is factory pre-set to Tone
position (T). In the UK, all telephone exchanges
now use Tone dialling.If your phone does not dial
out, it is probably being used from an older private
switch- board (PBX). In this case,theTone/Pulse
switch must be moved to Pulse (P).
SETTINGS
13
To Next Page
Loading...
