Alt+ to display template information
STEP 30
G0905058
Install the wheel nuts and hand tighten.
STEP 31
G0905071
Place two 10-ton hydraulic bottle jacks under the
frame in the location shown and apply upward
pressure equally from side to side on each jack.
STEP 32
G0905064
Remove the jack stands. Lower the bottle jacks
equally and remove.
STEP 33
Tighten the wheel nuts to a torque of 450 ft.-lbs. (610
Nm).
STEP 34
Remove the caps and plugs from the brake fittings
and hoses.
STEP 35
G090562
Install the two brake hoses to the fittings on the front
axle.
STEP 36
Remove the caps and plugs from the hydraulic
fittings and hoses.
To Next Page
Loading...
