46 917001/CP0905
Lifting the Loader
The loader can be lifted using a single-point or four-point lift kit, which is avail-
able from your Gehl dealer.
• Before lifting, check the lift kit for proper installation.
• Never allow riders in the operator’s compartment while the
loader is lifted.
• Keep everyone a safe distance away from the loader while it is
lifted.
• Loader may only be lifted with an empty bucket or empty pallet
forks, or with no attachment. Never lift the loader with attach-
ments other than those stated.
Lift equipment used and its installation is
the responsibility of the party conducting
the lift. All rigging MUST comply with
applicable regulations and guidelines.
1. Using suitable lift equipment, hook
into the lift eyes. Adjust the length of
the slings or chains to lift the loader
level.
Important: As needed, use a spreader bar
to prevent the slings or chains from rub-
bing the sides of the ROPS/FOPS. (Four-
point lift only)
Note: The loader my be slightly off level (10 degrees max.) when lifted,
depending on loader model and attachment (single-point lift only.)
2. Center the hoist over the ROPS/FOPS. To prevent shock loading of the equip-
ment and excessive swinging, slowly lift the loader off the ground. Perform all
movements slowly and gradually. As needed, use a tag line to help position the
loader.
WARNING
Figure 29 Single-Point Lift Eye
https://tractormanualz.com/
To Next Page
