917001/CP0905 51
Engine Speed Control
The throttle does not require routine adjustment. Refer to the Service Manual for
the initial setup procedure.
The throttle lever friction pad pressure can be adjusted if the throttle lever does
not hold its position. Belleville washers and a lock nut on the throttle lever are
used for making this adjustment.
Foreign Material Removal
The loader should be cleared daily of dirt and other foreign materials in the fol-
lowing areas:
• around the lift cylinders
• at the front of the loader
• on the hitch, especially around tilt cylinder
• around the hydraulic oil reservoir breather
• in the engine compartment
• in the operator’s compartment
Important: Build up of foreign materials in these areas can interfere with the
operation of the loader, cause component damage or become a fire hazard.
Lubrication
Listed below are the temperature ranges and types of lubricants for this machine.
Refer to the separate engine manual for more information regarding engine lubri-
cants, quantities and grades required.
Note: Refer to the specific service sections for detailed information on periodic
checking and replenishing of lubricants.
Refer to Figure 33 for grease fitting locations. Wipe dirt from the fittings before
greasing them to prevent contamination. Replace any missing or damaged fit-
tings. To minimize dirt build-up, avoid excessive greasing.
Important: Always dispose of waste lubricating oils and hydraulic fluids accord-
ing to local regulations or take to a recycling center for disposal. Do not pour
onto the ground or down the drain.
https://tractormanualz.com/
To Next Page
