Chapter 3 - Setup 65
© 2017 Geist
GM1157
Figure 3-35 SNMP Traps Configuration Page
Traps allows you to define the IP addresses and SNMP types that you wish the traps to be sent to.
Figure 3-36 SNMP Traps/Types IP Configuration Page
To configure a trap destination:
1. Locate the Traps section of the SNMP page, and click on the Add icon.
2. Enter the IP Address which the trap should be sent to in the Host field, change the Port number
if required, select the trap Version to be used (v1, v2c, or v3), and click Save.
A test trap may be sent by clicking on the Test icon next to the Host IP address. Trap settings can
also be updated/changed by clicking the Modify icon next to the Host IP address.
Syslog
Syslog data can be captured remotely but must first be setup and enabled via the Syslog page.
NOTE
This function is primarily only useful for diagnostic purposes, and should
normally be left Disabled unless advised to enable it by Geist technical
support for troubleshooting a specific issue
To Next Page
Loading...