www.gemu-group.com10 / 26GEMÜ 1235
24V / IO-Link, 3E, 4E
4 GEMÜ CONEXO
4 GEMÜ CONEXO
Order variant
In the corresponding design with CONEXO, this product has an RFID chip (1) for electronic identification purposes. The position
of the RFID chip can be seen below. The CONEXO pen helps read out information stored in the RFID chips. The CONEXO app or
CONEXO portal is required to view this information.
For further information please read the operating instructions for CONEXO products or the CONEXO datasheet.
Products such as the CONEXO app, the CONEXO portal and the CONEXO pen are not included in the scope of delivery and need
to be ordered separately.
5 Correct use
DANGER
Danger of explosion!
▶ Risk of death or severe injury
● Do not use the product in potentially explosive zones.
WARNING
Improper use of the product!
▶ Risk of severe injury or death
▶ Manufacturer liability and guarantee will be void
● Only use the product in accordance with the operating conditions specified in the contract documentation and in this docu-
ment.
The product is not intended for use in potentially explosive areas.
The product is designed for fitting to a GEMÜ valve in order to detect the position of linear actuators visually and electrically.
The product has a microprocessor controlled intelligent position sensor as well as an analogue travel sensor system (poten-
tiometer) which is positively connected with the actuator spindle by means of a mounting kit (spring, operating bush). The valve
end positions and the integrated travel sensor can be controlled via the electrical connections.
● Use the product in accordance with the technical data.
To Next Page
Loading...
Need help?
General
