www.gemu-group.com8 / 32GEMÜ 1434 µPos
4 GEMÜ CONEXO
3.5 Product label
Fritz-Müller-Str- 6-8
D-74653 Ingelfingen
88282795
1434000Z1A1430001010
24V Iw:4-20mA
single 15l/min
10524779 | 0001
-
2019
0-60° C
12
PST max 8,0bar
Item number
Batch number
Serial number
Design in accordance with
order data
Device version
Year of
manufacture
Max. permiss. control pressure
(at max. ambient temperature)
Ambient
temperature
Action/
flow capability
Supply voltage
NOTICE
Device version
▶ These instructions are valid for devices from device ver-
sion 10. It is possible to determine which firmware has
been used on the basis of the device version. For older
devices (device version older than 10), different operating
instructions with potentially different operating specifica-
tions are used.
Device
version
Firmware version Effective
from
Changes
10 V2.0.0.0 09/2013
11 V2.0.0.2 12/2013 Optimization of ini-
tialisation routine
for normally open
valves
12 V2.0.0.4 12/2016 Optimization of ac-
tuation behaviour
of small-volume lin-
ear actuators with
low stroke
4 GEMÜ CONEXO
Order variant
In the corresponding design with CONEXO, this product has
an RFID chip (1) for electronic identification purposes. The po-
sition of the RFID chip can be seen below. The CONEXO pen
helps read out information stored in the RFID chips. The CON-
EXO app or CONEXO portal is required to view this informa-
tion.
For further information please read the operating instructions
for CONEXO products or the CONEXO datasheet.
Products such as the CONEXO app, the CONEXO portal and
the CONEXO pen are not included in the scope of delivery and
need to be ordered separately.
To Next Page
Loading...
Need help?
General
