To Next PageTo Next PageWhat to do if my GEM 1434 mPos Valve Positioners show a device error?
If your GEM Valve Positioners are showing a device error, the issue might be related to the pneumatic system. First, check the pneumatic air supply to ensure it's properly connected and functioning. Then, inspect all pneumatic connections for any signs of leakage. Addressing these potential issues with the air supply and connections should help resolve the error.
Why is the set value too high in my GEM 1434 mPos?
If the set value is too high in your GEM Valve Positioners, it might be because the set value signal exceeds 20.5 mA or 10.25 V. To resolve this, check the set value signal to ensure it is within the correct range.
What to do if the set value signal is too low in GEM Valve Positioners?
If the set value signal is too low in your GEM Valve Positioners, specifically below 3.5 mA, you should check the set value signal to ensure it's within the appropriate range.
How to fix GEM Valve Positioners operating with lower quality?
If your GEM Valve Positioners are operating with lower quality, the internal valves may not have been measured accurately during initialization. Here are a few things you can check: * Check the process valve for any leakage. * Ensure the process valve has free and easy movement. * Prevent unstable medium pressure during initialization; if possible, turn off media pressure.
General| Brand | GEM |
|---|---|
| Model | 1434 mPos |
| Category | Valve Positioners |
| Language | English |
