Gemalto AT10K User Manual

Document Reader AT10K User Guide Installing the Reader
Page 17 of 29
Install the software
The reader package contains an instruction sheet with links to a customer portal to download the software
components and documentation necessary to install and operate the reader:
 Gemalto Document Reader SDK
 Reader and software documentation
 Required drivers
 Additional SDKs based on the reader model
To install the reader software:
1. Download the latest SDK software from the link. Click on the Gemalto Document Reader SDK x.x.x
Setup.exe link and save the exe file to a known location on the host PC (for example, the
desktop).
2. Run the downloaded .exe file and follow the on screen instructions.
Connect the reader cables
Note: Make sure you install the software before connecting the reader.
To install the reader, you need to connect the following cables:
 USB cable – The reader is supplied with a USB 2.0 cable (Type A to Type B). The cable provides
both power and data connectivity to the reader.
Type B (connects to reader)
Type A (connects to PC)
 Power supply (optional) – You need to use the optional power supply (PSU) if you want to use the
reader as a powered USB2.0 hub and with Linux and macOS. The Power connector is a latching
type that cannot accidentally detach as the reader is moved about. To remove the connector,
grasp the connector shell and pull away from the reader. .
To connect the reader cables:
Note: Use on the USB cable and optional PSU provided with the reader.
Modifications or changes to the Product, the interface cables or the power
supply not expressly approved by the manufacturer could void the User's
authority to operate the Product and/or break local laws or regulations.

Gemalto AT10K Specifications

General

Brand	Gemalto
Model	AT10K
Category	Card Reader
Language	English