Gemalto SafeNet Luna Network HSM 7.0 User Manual

1 SafeNet Luna Network HSM Hardware Installation
port (on the rear panel's left side), using the included USB-to-MiniUSB PED cable. See also "SafeNet Luna
Remote PED Installation and Configuration"on page 26. If you have a password-authenticated HSM, skip to the
next step.
Note: The PED must be connected to a suitable power source. The USB 2.0 connection does
not provide enough power to run the PED.
3. Press and release the Start/Stop switch on the front panel.
4. Connect the terminal port on the HSM appliance's rear panel to a dumb terminal, PC, or laptop, using the USB-to-
RJ45 adapter cable (supplied). This terminal provides serial access to LunaSHfor initial network configuration. See
"Open a Connection"on page1 for more information.
SafeNet Luna Network HSM Installation Guide
Release 7.0 007-013576-002 Rev. A June 2017 Copyright 2001-2017 GemaltoAll rights reserved.
24

Gemalto SafeNet Luna Network HSM 7.0 Specifications

General

Brand	Gemalto
Model	SafeNet Luna Network HSM 7.0
Category	Network Hardware
Language	English