GEMAŞ Genel Mühendislik Mekanik San.ve Tic.A.Ş.
İTOB Organize Sanayi Bölgesi 10001 Sok.No:28 Menderes/İZMİR TURKEY
Tel:0232 799 0 333 Fax:0232 799 0 330 www.gemas.com.tr info@gemas.com.tr
2.2. Power Unit Installation
• The power unit must be considered at a maximum distance of 1.5 m from the device.
• Mark the hole locations on the wall that you will install for mounting.
• Secure the power unit with the help of dowels and screws.
• Connect the ground wire (yellow and green) of the 220V AC power unit cable to the grounding line on the
panel. Connect the phase (brown) and neutral (blue) wires to the outputs of the pump contactor.
Salt chlorine generator must be used parallel to the pump and while the water is
circulating in the cell. The device must not be operated without water flow in the cell.
2.3. Pool Water
It is recommended to use mains water for the pool. If you are supplying water from other sources, please
analyze the water and make sure that there are no high concentrations of metals and calcium that are not
suitable for the operation of the system. Also check the compliance of water with human health standards.
Before operating the salt chlorine generator, adjust the pool water values and discard 1 kg of chlorine
stabilizer for 25 m3 of water (20-30 ppm or as specified by the stabilizer manufacturer).
Stabilizer prevents chlorine from disappearing due to UV rays. Stabilizer deficiency forces
more chlorine production, which shortens the life of the cell. On the other hand, the high
stabilizer affects the disinfection feature of chlorine.
The water of the pool must meet the following values.