.
When the batteries are low, the battery icon will come on and flash.
The two AA Batteries in the unit need to be replaced. In some installations your
heater system will stop functioning when the thermostat loses power. Replace
batteries as soon as you see this warning. The thermostat programs will remain
for 30 seconds while the batteries are removed and replaced.
.
Do not take longer than 30 sec to change the batteries in your unit
or you will lose all custom settings and all programming. Only the
Energy-Star
TM
program will remain. Once the batteries are replaced,
the system will return to normal in 2 seconds.
NOTE: Your thermostat comes from the factory calibrated to + or - 1 degree F. It is an
accurate instrument. If you want your thermostat to display the same temperature as
another thermometer in your home, you can adjust its calibration.
To change the calibration:
.
Mode switch of the unit must be in the HEAT or COOL position.
.
Press the <Time
.
Press the Temp Up/Temp Down buttons to adjust the temperature reading.
.
Press HOME to save the new setting.
Calibration
Low Battery
PG
10
TIME
4 Special Features cont.
To Next Page
Loading...
