21 Declaration of Incorporation
Declaration of Incorporation
according to the EC Machinery Directive 2006/42/EC, Annex II, 1.B
for partly completed machinery
Manufacturer: GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Postfach 30
Fritz-Müller-Straße 6-8
74653 Ingelfingen-Criesbach, Germany
Description and identification of the partly completed machinery:
Make: GEMÜ diaphragm valve, pneumatically operated
Serial number: from 29.12.2009
Project number: MV-Pneum-2009-12
Commercial name: Type 650
We hereby declare that the following essential requirements of the Machinery Directive
2006/42/EC have been fulfilled:
1.1.3., 1.1.5., 1.2.1., 1.3., 1.3.2., 1.3.3., 1.3.4., 1.3.7., 1.3.9., 1.5.3., 1.5.5., 1.5.6., 1.5.7., 1.5.8., 1.5.9., 1.6.5.
We also declare that the specific technical documentation has been compiled in accordance with
part B of Annex VII.
We expressly declare that the partly completed machinery complies with the relevant provisions of
the following EC directives:
2006/42/EC:2006-05-17: (Machinery Directive) Directive 2006/42/EC of the European Parliament
and of the Council of 17 May 2006 on machinery, and amending
Directive 95/16/EC (recast) (1)
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned request
by the national authorities, relevant information on the partly completed machinery. This transmission takes
place:
electronically
This does not affect the industrial property rights!
Important note! The partly completed machinery may be put into service only if it was determined,
where appropriate, that the machinery into which the partly completed machinery is to be installed
meets the provisions of this Directive.
Joachim Brien
Head of Technical Department
Ingelfingen-Criesbach, September 2018
50 / 52
650
To Next Page
Loading...
