GENASYS 360 - Terminal Blocks

GENASYS 360
GENASYS INC.
Manual Part NO.: 119509-00 Rev. A
5
3.3 Terminal Blocks
ST0 (the base stack) contains the terminal blocks used to connect the acoustic drivers to the
audio source. These terminal blocks are installed on a DIN rail that is mounted inside ST0
(Figure 3).
Internal connection cables run down from the acoustic drivers in the upper stacks and connect
to the tops of the terminal blocks. Cables from the audio source connect to the bottoms of the
terminal blocks.
Section 6.0 provides more information on connecting the 360 to its audio source via these
terminal blocks.
Figure 3