Gendex DenOptix QST User Manual

DenOptix QST
032-0265-EN Rev 1D-2
Guidance and manufacturer’s declaration - electromagnetic immunity
The Gendex QST is intended for use in the electromagnetic environment specified below. The
customer or the user of the Gendex QST should ensure that it is used in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic
environment –
guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
+/-6 kV contact
+/-8 kV air
+/-6 kV contact
+/-8 kV air
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material,
the relative
humidity should be
at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
+/-2 kV for power
supply lines
+/-1 kV for input/
output lines
+/-2 kV for power
supply lines
+/-1 kV for input/
output lines
Mains power quality
should be that of a
typical commercial
or hospital
environment
Surge
IEC 61000-4-5
+/-1 kV line(s) to
line(s)
+/-2 kV line(s) to
earth
+/-1 kV line(s) to
line(s)
+/-2 kV line(s) to
earth
Mains power quality
should be that of a
typical commercial
or hospital
environment.
Voltage dips,
short
interruptions
and
voltage 
variations
on power
supply
input lines
IEC 61000-4-11
<5% U
T
(>95% dip in U
T
) for
0.5 cycle
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
<5% U
T
(>95% dip in U
T
)
for 5 sec
<5% U
T
(>95% dip in U
T
) for
0.5 cycle
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
<5% U
T
(>95% dip in U
T
)
for 5 sec
Mains power quality
should be that of a
typical commercial
or hospital
environment. If the
user of the Gendex
QST requires
continued
operation during
power mains
interruptions, it is
recommended that
the Gendex QST be
powered from an
uninterruptible
power supply or a
battery

Gendex DenOptix QST Specifications

General

Brand	Gendex
Model	DenOptix QST
Category	Dental equipment
Language	English