Genelec 8010A - System Specifications; Amplifier Section; Crossover Section

8040B Data Sheet
Genelec Document BBA0003001a Copyright Genelec Oy 4.2007. All data subject to change without prior notice
www.genelec.com
Figure 3: The upper curve group shows the horizontal directivity char-
acteristics of the 8040B measured at 1 m. The lower curve shows the
systems power response.
Figure 4: The curves above show the effect of the “bass tilt”, “treble
tilt”, “desktop low frequency” and “bass roll-off” controls on the free field
response.
AMPLIFIER SECTION
CROSSOVER SECTION
SYSTEM SPECIFICATIONS
8040B
Lower cut-off frequency, -3 dB
Upper cut-off frequency, -3 dB
≤ 45 Hz
≥ 20 kHz
Free field frequency response of system (± 2.0 dB) 48 Hz - 20 kHz
Maximum short term sine wave acoustic output on axis in half
space, averaged from 100 Hz to 3 kHz
@ 1 m
@ 0.5 m
≥ 105 dB SPL
≥ 111 dB SPL
Maximum long term RMS acoustic output in same conditions
with IEC weighted noise (limited by driver unit protection circuit)
@ 1 m
≥ 99 dB SPL
Maximum peak acoustic output per pair above console top,
@ 1 m from the listening position with music material
≥ 115 dB SPL
Self generated noise level in free field @ 1m on axis
(A-weighted)
≤ 10 dB
Harmonic distortion at 90 dB SPL @ 1m on axis
Freq. 50 to 100 Hz
> 100 Hz
< 2 %
< 0.5 %
Drivers:
Bass
Treble
Both drivers are magnetically shielded
165 mm (6
1
/
2
in) cone
19 mm (
3
/
4
in) metal dome
Weight: 8.6 kg (18.9 lbs)
Dimensions:
Height (without Iso-Pod table support
Height (including Iso-Pod table support)
Width
Depth
350 mm (13
13
/
16
in)
365 mm (14
3
/
8
in)
237 mm (9
3
/
8
in)
223 mm (8
13
/
16
in)
8040B
Bass amplifier short term output power
Treble amplifier shortterm output power
Long term output power is limited by driver unit protection
circuitry
90 W (8 Ohm load)
90 W (8 Ohm load)
Amplifier system distortion
at nominal output
THD
SMPTE-IM
CCIF-IM
DIM 100
≤ 0.05 %
≤ 0.05 %
≤ 0.05 %
≤ 0.05 %
Signal to Noise ratio, referred to full output
Bass
Treble
≥ 100 dB
≥ 100 dB
Mains voltage 100,120,220or230V
according to region
Voltageoperatingrange ±10 %
Power consumption
Standby
Idle
Full output
<0.5 W
10 W
110 W
8040B
Input connector XLR female Pin 1 gnd, pin 2 +, pin 3 -
Input impedance 10 kOhm balanced
Input level for maximum short term output of 100 dB SPL @ 1m Variablefrom+6to-6dBu
Crossover frequency, Bass/Treble 3.0 kHz
Treble tilt control operating range in 2 dB steps From+2to-4dB&MUTE
@ 15 kHz
Desktop low frequency control operating range -4 dB @ 160 Hz
Bass roll-off control operating range in 2 dB steps From 0 to -6 dB @ 45 Hz
Bass tilt control operating range in 2 dB steps From0to-6dB&MUTE
@ 100 Hz
The 'CAL' position is with all tone controls set to 'off' and the
input sensitivity control to maximum (fully clockwise)
20
20k
50
100
200
500
1k 2k
5k
10k
Hz
Genelec Oy 8040 (dBr) vs freq (Hz) 6 Apr 04
80
85
90
d
B
r
A
DESKTOP LF
BASS TILT
BASS ROLL-OFF
TREBLE TILT
80
85
90
80
85
90
20
20k
50
100
200
500
1k 2k
5k
10k
Hz
Genelec Oy 8040 horizontal off axis response level (dBr) vs freq (Hz) 6 Apr 04
0°
60°
15°
30°
45°
50
100
55
60
65
70
75
80
85
90
95
d
B
r
A
100
90
95
International enquiries:
Genelec, Olvitie 5
FIN-74100, Iisalmi, Finland
Phone +358 17 83881
Fax +358 17 812 267
Email genelec@genelec.com
In the U.S. please contact:
Genelec, Inc., 7 Tech Circle
Natick, MA 01760, U.S.A.
Phone +1 508 652 0900
Fax +1 508 652 0909
Email genelec.usa@genelec.com
In Sweden please contact:
Genelec Sverige
Box 5521, S-141 05 Huddinge
Phone +46 8 449 7070
Fax +46 8 708 7071
Email info@genelec.com
In China please contact:
Beijing Genelec Audio Co. Ltd.
Jianwai SOHO, Tower 12, Room 2306
39 East 3rd Ring Road
Chaoyang District, Beijing 100022, China
Phone +86 10 5869 7915
Fax +86 10 5869 7914