Unpacking and assembling
Remove the two large pieces of foam
padding.
3.
Remove both ampliers and take them out
of their plastic bags.
4.
Remove screws from the box’s base and lift
the box’s top section away.
1.
Remove accessory box, then cut incliner
wedges free and remove them.
2.
70
kg
!
Torx 20
(Optional) If tilting is needed, install incliner
wedge onto lower enclosure. Attach with
4 pcs M4x10 torx bolts.
6.
Remove plastic bag from the lower enclosure
and lift lower enclosure to nal location.
5.
70
kg
!
Torx 20,
max. 1Nm
F x 4
To Next Page
Loading...
