Introduction and Safety
8 Owner’s Manual for MLT6SMD Light Tower
Safety and Operating Decals
See Figure 1-1 through Figure 1-3. This unit features
numerous safety and operating decals. These decals
provide important operating instructions and warn of
dangers and hazards. The following diagrams illustrate
decal locations and descriptions.
Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit. Decal part numbers
can be found in the parts manual at
www.generacmobileproducts.com.
ID Description ID Description
1 Stowed Position 14 Safety Alert—Read Owner’s Manual
2 Warning—Do Not Retract Outriggers With Tower Up 15 Warning—Electrical Storms and High Wind
3 Notice—Avoid Tangling Winch Cable 16 Danger—Do Not Operate Beneath Electrical Wires,
In Electrical Storms, or In High Winds.
Read Owner’s Manual. Do Not Tow With Mast Raised.
4 Electric Shock Hazard 17 Warning—Hot Surface
5 Lifting Point 18 Warning—Pressurized Liquid
6 Forklift and Tie-Down Point 19 Disconnect Battery Before Servicing
7 Owner’s Manual Location 20 Warning—Do Not Remove Guard. Hot Surface,
Entanglement, and Cutting Hazards.
8 Engine Operation 21 Warning—Cutting Hazard
9 Danger—Fuel and Fueling Hazards 22 Warning—High Temperature: Do Not Remove Guard
10 Ultra Low Sulfur Diesel Fuel Only 23 Electrical Ground Connection
11 Not A Step 24 Neutral Bonded to Frame
12 Tie-Down Point 25 Setup and Take-Down Instructions
13 Towing Instructions — —
To Next Page
Loading...
Need help?
General
