Generac Power Systems MLT6SMD User Manual

Operation
Owner’s Manual for MLT6SMD Light Tower 35
4. Before starting the engine, unplug the extension
cord from the power first, then unplug the heater
cord set from the extension cord.
Tandem Tow (If Equipped)
See Figure 3-7. The tandem tow hitch option (A) allows
the operator to tow a second MLT6 Light Tower in series
behind the unit equipped with the hitch.
IMPORTANT NOTE: Never tow more than two units
at once.
• Connect any trailer wiring to the unit in front (B).
Inspect for proper operation of the directional and
brake lights.
• Connect the towing chains to the tie down locations
(C).
• Avoid sharp turns when towing. Do not cross any
obstacles more than 12 in (30.5 cm) deep.
• Tandem tow speeds:
a. Paved highway—45 mph (72 km/h)
b. Graded gravel—25 mph (40 km/h)
c. Cross country—10 mph (16 km/h)
Figure 3-7. Tandem Tow
Telemetry (If Equipped)
The digital telemetry option allows the operator to
remotely monitor the unit fuel level (depending on the
type of telemetry selected, and other optional equip-
ment). A transmitter inside the engine compartment
sends real time equipment status information to the user
via cellular or satellite connection.
Spark Arrester (If Equipped)
A spark arrester, installed on the unit exhaust, may be
required by code in certain municipalities. Contact the
local authority having jurisdiction to determine whether or
not a spark arrester must be installed on the unit before
operation.
Lowering the Mast—Manual
Winch
1. Shut down the lights and engine. See Shutting
Down the Unit.
2. Lower the mast.
3. Collapse the mast to its lowest position using the
winch handles. Verify the electrical cord does not
get caught in, or pinched by, the mast while it is
being lowered.
IMPORTANT NOTE: Contact a GMP ASD immedi-
ately if the mast hangs up or the winch cable devel-
ops slack.
4. See Figure 3-8. I
f the unit is going to be moved,
rotate the mast so the lights face the rear of the unit
.
Figure 3-8. Stowed (Travel) Position
To rotate the mast:
a. Loosen the mast rotation knob.
b. Rotate the mast until the white arrows are
aligned and the metal stop tabs are touching.
c. Tighten the mast rotation knob.
004770
A
B
C
C
WARNING
Personal Injury. Stop immediately if the mast hangs
up or the winch cable develops slack. Excess slack
could cause the mast to collapse, resulting in personal
injury or equipment damage.
(000265)
003275

Generac Power Systems MLT6SMD Specifications

General

Brand	Generac Power Systems
Model	MLT6SMD
Category	Lighting Equipment
Language	English