Quick Reference Guide I 24
23 I Quick Reference Guide
GENESIS G90
FEATURES AND CONTROLS
REMOTE SMART PARKING ASSIST
Remote Operation
Remote Operation functions in the following order:
1. Getting ready to remotely move forward and backward
There are two ways to operate Remote Operation function.
Method 1, Using the function with engine off.
(1) Within a range from the vehicle press the door lock button on the smart
key and lock all doors.
(2) Press and hold the Remote Start button for 4 seconds until the engine
starts.
Method 2, Using the function with engine on.
(1) Park the vehicle in front of the space where you want to use Remote
Operation function and shift the gear to P (Park)(1).
(2) Press and hold the Parking/View (2) button to turn on Smart Parking
Assist. A message ‘Remote Parking Instructions’ will appear on the
infotainment system screen.
(3) Get out of the vehicle with the smart key and close all doors.
2. Remotely moving forward and backward
(1) Press and hold one of the Forward or Backward button on the smart
key. Remote Smart Parking Assist will automatically control the steering
wheel, vehicle speed and gearshift. The vehicle will move in the direction
of the button pressed.
(2) While Remote Operation function is operating, if you do not hold down
the Forward or Backward button, the vehicle will stop, and function
control will pause. The function will start operating again when the
button is pressed and held again.
(3) When the vehicle reaches the target location, release the smart key
Forward or Backward button.
(4) When the driver gets in the vehicle with the smart key, a message will
appear informing the driver Remote Operation function is complete on
the infotainment system screen and the engine will remain on.
In addition, when the Remote Start button is pressed on the smart key
from outside the vehicle, a message will appear informing the driver
Remote Operation function is complete and the engine will turn off.
To Next Page
Loading...
