Quick Reference Guide I 52
51 I Quick Reference Guide
GENESIS G90
DRIVING
TIRE PRESSURE MONITORING SYSTEM (TPMS)
Low Tire Pressure Indicator /
TPMS Malfunction Indicator
LOW TIRE PRESSURE INDICATOR
Illuminates if one or more of your tires are significantly under-inflated.
TPMS MALFUNCTION INDICATOR
Blinks for approximately one minute, then remains illuminated when there is
a malfunction with the TPMS. Inspect all tires and adjust the tire pressure to
specification. If the lamp remains illuminated, we recommend the vehicle be
checked by an authorized GENESIS dealer.
LOW TIRE PRESSURE / TIRE PRESSURE MONITOR /
TPMS MALFUNCTION DISPLAY(LCD DISPLAY)
Low Tire Pressure /
Tire Pressure Monitor /
TPMS Malfunction Display
(shown on the cluster
LCD display)
Select the Driving Assist mode by pressing the mode button on the
steering wheel to display tire pressure.
Tire pressures will display after driving a short distance. If a tire pressure
drops lower than predetermined specification, the Low Tire Pressure
Indicator will illuminate and the cluster
display will indicate tire(s)
requiring air.
NOTE:
Environmental factors can affect the tire pressure. The two main
environmental factors are ambient air temperature and elevation. Colder
ambient air will reduce tire pressure, while hotter ambient air will increase
tire pressure. High elevation may also increase tire pressure.
Rear Cross-Traffic Collision
Warning
When the vehicle is in R (reverse), the
system provides an alert if a vehicle is
approaching from the sides.
2
31
BLIND-SPOT COLLISION WARNING (BCW)
Blind-Spot Collision Warning (BCW)
system uses radar sensors in the rear
bumper to monitor and warn the
driver when it detects an approaching
vehicle in the driver's blind spot area.
1
Blind-Spot Area
2
Lane Departure Warning
3
Rear Cross-Traffic Collision Warning
To turn on/off select or deselect
‘Driver Assistance → Blind-Spot
Safety’ from the Settings menu to
set whether to use each function.
FORWARD COLLISION-AVOIDANCE ASSIST (FCA)
Forward Collision-Avoidance Assist (FCA)
system is designed to help detect and monitor
the vehicle ahead in the roadway through
camera recognition to warn the driver that a
collision is imminent, and if necessary, apply
emergency braking. On vehicles equipped
with both front view camera and front radar
sensor, a cyclist detection is also available.
Setting Forward Safety function
The driver can activate FCA by placing the
ignition switch to the ON position and by
selecting:
Driver Assistance → Forward Safety’ from the
Settings menu to set whether or not to use
each function.
Warning Only- Braking assist is not applied
Off- System deactivates
To Next Page
Loading...
