Quick Reference Guide I 48
GENESIS G90
47 I Quick Reference Guide
DRIVING
SHIFT BY ROTARY GEAR SHIFTER
IDLE STOP AND GO (ISG)
To change the gear, depress the brake
pedal and rotate the rotary gear shift dial.
A
P button
B
Rotary shifter (Rotary gear shift dial)
To shift the gear to P (Park), press the P
button while depressing the brake
pedal.
If you turn the vehicle off in R (Reverse),
N (Neutral) or D (Drive), the gear will
automatically shift to P (Park).
Idle Stop and Go helps reduce fuel
consumption by automatically shutting
down the engine, when the vehicle is at
a standstill (for example, red stop light,
stop sign, and traffic jam) subject to
certain prerequisite conditions.
The engine is automatically started upon
satisfying the starting conditions.
ISG system is always active, when the
engine is running.
Press the ISG OFF button to turn off ISG
system. The ISG OFF button indicator
will illuminate. To use the system, press
the ISG OFF button again.
ISG will default to on at every ignition on.
Even if it was turned off at the last
engine off.
A
B
SMART CRUISE CONTROL
Turning on Smart Cruise Control
Setting vehicle distance
Increasing set speed
Decreasing set speed
Press the Driving Assist ( ) button to
turn on Smart Cruise Control. The
speed will be set to the current speed
on the cluster.
Each time the button is pressed, the
headway changes as follows:
Push the + switch up and release it
immediately. The set speed will
increase by 1mph (1 km/h) each time
the switch is operated in this manner.
Push the - switch down and release it
immediately. The set speed will
decrease by 1mph (1 km/h) each time
the switch is operated in this manner.
B
A
Distance 2
Distance 3Distance 4
Distance 1
Note: Quick toggle up/down will
change speed by 1 mph. Holding
switch up/down will change speed
by 10 mph.
Temporarily canceling Smart
Cruise Control
Press the switch or depress the
brake pedal to temporarily cancel
Smart Cruise Control.
A
Operating
B
Temporarily canceled
To Next Page
Loading...
Need help?
General
