Genesis GV80 2024 - Homelink Wireless Garage Control System

26
4 INFOTAINMENT
HOMELINK WIRELESS GARAGE CONTROL SYSTEM
Press and release button , , or .
• If the indicator illuminates and is orange, go to Step 3
(programming mode).
• If the indicator illuminates and shows a solid or flashing green
light, go to Step 2 (erasing mode).
1 2
3
7
7
Erasing Mode
Press and hold the button you wish to program for approximately 15-25
seconds, until the LED flashes orange several times. This indicates any
prior programming has been erased.
Programming Mode
Hold the original garage door opener/transmitter near the HomeLink
Mirror.
Press and hold the original transmitter button until the HomeLink
indicator shows a solid green light, or flashes green for
approximately 10 seconds. This indicates that the programming has
been completed.
NOTE: If the indicator flashes green continuously but the garage
door opener does not operate, please follow the Rolling Code
Programming steps shown below.
7
7
Some new garage door openers come equipped with a two-way
communication feature. If your garage door opener has this feature,
follow the Rolling Code Programming steps shown below.
Indicator
4
&
6
:
Flashes in orange → “Closing” or “Opening”
4 6
•
•
Solid Green → “Closed” or “Opened”
7
Two-Way Communication